OZGU-370SE

Ozone Transferstandard

The calibration unit OZGU-370SE is designed for the dynamic and continual manufacture of zero and span gas to perform all ongoing quality control procedures according EN 14625. Transferstandard OZGU-370SE is based on well proven Analyzer APOA-370 with integrated span gas generation unit (ASGU-370 Electronic). This Span gas unit is able to provide ozone gas to an 2nd Ozone monitor. The actual concentration is measured by the type approved measurement cell of the transfer standard. The measured concentration is used as set point for the 2nd Ozone analyzer (measurement unit to be calibrated).

Segment: Process And Environmental

Division: Ambient

Manufacturing Company: HORIBA, Ltd.

Base product: APOA-370

Multipoint calibration acc. EN 14625
Comfortable operation via 2 big illuminated Touch-Screen-Displays or remote software enables easy external handling
High flexibility through 20 free selectable span points
High flexibility through free definable cycles (e.g. Lack of fit)
High flexibility through free definable sequences (stringing cycles together)
Programmable timer allows time delayed start of calibration process
Internal data logger (option) stores raw values from calibration procedure (set value and actual value, status) for reporting with included evaluation software

Technical Specification (Analyzer)
Refer to APOA-370, Ozone Analyzer
Technical Specification (Span Gas Generator Unit)
Principle	UV irradiation
Application	Quality control in Station Quality control in Laboratory Preparing Zero and Span gas for O₃ multi point calibration
Ozone generation by UV Irradiation	Intensity controlled mercury lamp in a oven with a heater and Pt 100 sensor (Temperature: 70C°) Indication of actual temperature on display
Zero Air Supply	External cartridge (mounted on unit)
Selectable span gas concentrations	20 (Option: controlled ozone set values)
Selectable cycles	8
Programmables sequence	yes
Programmable timer	yes
Evaluation software	Option
Datalogger	Option
Indication	TFT touch screen displays with simultaneous indication of information, relevant for calibration
Operation	Manual (Touch Screen Display) External via RS232 (Gesitec Protocol) External via Ethernet (Remote Software)
Power	230VAC, 50Hz
Dimension	430mm(W), 550mm(D), 221mm(H)
Mass	17kg